Templar's Gear PT2 Battle Belt with Fixed Inner Belt, Multicam (Ballistic Protection Compatible, No Buckle)

Note! The belt is otherwise a standard PT2 belt, but the buckle is not included. Remember to  get a suitable buckle which can be adjusted on both sides. You may also sew one end of the belt so that the buckle is more fixed, or use a suitable tri-glide instead. The width of the belt is 44 mm. This AustriAlpin Cobra buckle with D-ring is perfect, but other 45 mm wide buckles are fine too, you just have to do the mods mentioned earlier. The Templar’s Gear PT2 is a padded and stiffened gear belt, which has a fixed inner belt. This of course means that you cannot change the belt, but at least the inner belt will stay in place instead of moving around. An excellent KISS (Keep It Simple, Stupid) solution as a battle belt to be worn with a plate carrier, or alone as a base for lighter combat gear! Features Stiffened and padded structure – comfortable to carry and heavy items won’t bend the belt. You can also remove the internals through the zipper on the back. Four D-ring attachment points for a harness There are points between PALS loops on the sides, from where you can make the inner belt run on top of the battle belt, for example for attaching a pistol holster. Excellent attachment possibilities: a 6 × 2 PALS matrix on the sides. On the back there is a 4 × 2 matrix. Weight: 520 g Manufactured from 500 denier Cordura About the size The size should be chosen so that the ends won’t go on top of each other but stay on the sides. This gives your legs more room to move and when there are no pouches on the front pressing your stomach, it is easier to get flat on the ground and be a smaller target. The PALS-laced part of the belt is 85 cm. Templar’s Gear – laser cut quality Templar’s Gear represents the renaissance of European military gear manufacturers that began in the 21st century. American manufacturers dominated the tactical gear market for a long time, but the Old World was not yet ready to throw in the towel. In this continuum, Templar’s Gear represents the leading edge of high-quality, modern and well-designed gear. The defining characteristic of the company is that their products are manufactured using laser cutting and 500 denier Cordura, which makes the products a lot lighter without compromising reliability. Special attention has been paid to quality control in Templar’s pouches and gear, because a significant portion of the company’s customers are officials, whose safety and well-being might depend on the gear. The materials used by Templar’s Gear are IRR protected, so the user won’t glow in the night vision devices like a Ukrainian firefighter. Cooperation - Yhteistyö - Współpraca Templar's Gear products are delivered to us straight from the factory in Poland. This means that our product selection is updated to the latest and greatest generation almost in real time as replenishments are ordered. Thanks to the close cooperation and our frequent orders, we also have a chance to forward feedback and new ideas to the respective designers. If you as a user have any ideas for product development, we are happy to share them with Templar's Gear. Extended three-year warranty Templar’s Gear products are granted a three-year warranty. In more concrete manner this means that for example products sold this spring will have warranty for three action packed seasons of airsoft, shooting or whatever you decide to do with them. The warranty covers all problems that might arise from defective materials or poor craftsmanship. Carelessness or misuse voids the warranty.