Water is the basic element of life and it is difficult to be without it. In addition, Clawgear's hydration carrier is lightly insulated, which means that in winter conditions the water stays liquid longer and cooler when weather is hot. The PALS/MOLLE matrix of the outer surface can be used to attach other necessities and the large opening makes it easier to access the bladder. Features: Lightly insulated - doesn't add much weight or profile, but gets the job done.On the closing flap there is a 22.5 x 5 cm loop Velcro matrix for IFF markings and morale raising patches. There are also loops in the corners of the closing flap that make opening the flap easier. The flap closes with Velcro.Outside is covered with a 6 x 7 PALS matrix. A full water load naturally also bulges the PALS matrix.One-Wrap loop for hanging the bladder at the top of the bladder section.Drainage hole at the bottom.Height 39~40 cm, depending on how tight you close the flap. Width in the middle and at the top is 22.5 cm, at the bottom 20 cm. Bottom piece depth is estimated at 9 cm, but the water bladder placed inside affects the dimensions. The bottom piece bulges outwards if necessary, giving more space for the hydration bladder.Takes in a 3 liter bladder, bladder not included! Source's WLPS and WXP series bladders are good friends with this one. WXP works a little better and uses the entire capacity more efficiently.When attached the carrier takes 4 x 7 space on a PALS matrix. So it is slightly longer than most plate carriers and back panels by one row, but at least it can hold loads of water!If necessary, it also works as a small backpack or as an assault panel, especially when combined with a removable back panel.The color is RAL7013, which is very close to Ranger Green.Made of 500D Cordura. Weight 240 g.
